From slap-back echo, ping-pong delay, and tempo-sync with modulation, to filtering, flanging, phasing, and more, Waves H-Delay (Hybrid Delay) delivers real old school effects, controlled by a super intuitive interface.
Controls
- Delay
-
Sets the delay time. Range: 1 ms to 3500 ms or BPM multiple (e.g. 1/4 note, 1/8 note, 1/16 note, etc.).
- Sync
-
Sets whether delay time is based on to the host tempo or set manually using time (ms) or BPM multiplier.
- Depth
-
Sets the amount of modulation to be applied. Range: 0 to 100.
- Rate
-
Sets the modulation LFO cycle rate. In BPM or Host Sync mode, the value is a multiplier of the BPM. In MS Sync mode, the rate value is expressed in Hz. Range: 0.1 to 6000 Hz or BPM multiples
- Phase
-
Reverses the phase for the LR delay lines.
- Ping Pong
-
Activates Ping Pong delay effect mode, spreading the repeats over the stereo image.
- Feedback
-
Sets the amount of feedback signal back into the delay, which controls the level and amount of repeats. At settings of 100 to 200, it controls the delay repetition buildup (which can be used as an “endless” loop). Range: 0 % to 200 %.
- LP / HP Filters
-
Controls the Low-pass and High-pass filters frequency cutoff. Range: Off, 20 Hz to 20 kHz
- Filter Link:
-
Use the Link rotary control to move the HP and LP filters together, which makes them work as a Band Pass filter.
- Dry/Wet Mix:
-
Controls the amount of the Dry unprocessed signal (0) vs the processed Wet signal (100). Range 0 to 100.
- Analog
-
Sets the analog character preset, which influences noise and saturation. Range: Off, Mode 1 to 4.
- LoFi
-
Activates the LoFi effect, which influences the frequency response of the delay line.
- Output
-
Controls the output level. Range: -18 dB to +18 dB.
- Tap Pad
-
Sets the delay time based on your clicks on the pad. Delay Time is set as the interval between the last two clicks. In Host and BPM Sync modes, the delay time will be quantized to the nearest note value.