You can change the width of individual multi-bar rest H-bars.
This allows you to control the exact positions of multi-bar rests; for example, when there are clef changes at the end of multi-bar rests.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
Graphic Editing
is selected in the Engrave toolbox.
Procedure
- In Engrave mode, select the multi-bar rests whose width you want to change.
- In the Properties panel, activate H-bar width delta in the Multi-bar Rests group.
- Change the value in the value field.
Result
The width of the selected H-bars is changed. Increasing the value increases their width, decreasing the value decreases their width.