Down arpeggio signs have an arrowhead at the bottom of the line by default, but up arpeggio signs have no arrowhead by default. You can change the appearance of the ends of arpeggio signs individually, independently of your project-wide settings.
These steps only apply to up and down arpeggio signs. They do not apply to curved or non arpeggio signs.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the arpeggio signs of any direction whose ends you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Sign end in the Arpeggios group.
-
Select the end you want from the menu:
-
Nothing
-
Arrow
-
Swash
-
Result
The appearance of the ends of the selected arpeggio signs is changed.
You can change the default appearance of the ends of all arpeggio signs project-wide on the Arpeggio Signs page in Engraving Options.
Example
|
|
|