Guitar pre-bends and pre-dives

Dorico Pro Help

Product
Dorico Pro
Version
4.3
Language
English
Document type
Webhelp
ft:openMode
fluidtopics

Guitar pre-bends and pre-dives are techniques commonly performed on electric guitars, where the performer changes the initial sounding pitch of strings before playing notes, either by bending strings to tighten them or using the vibrato bar to loosen them.

A phrase containing a guitar pre-bend with release and multiple guitar pre-dives with release

In Dorico Pro, guitar pre-bends and pre-dives are properties of notes belonging to fretted instruments, meaning they only apply to single notes.

Guitar pre-bends

Guitar pre-bends indicate that the performer should bend the string before playing the note to raise the pitch; for example, to repeat a note that was at the end of a previous guitar bend. The pitch can then be lowered after starting to sound.

On notation staves, guitar pre-bends are notated using an angled line between the noteheads at the start and end. However, unlike guitar bends, the parenthesized auxiliary notehead at the start is shown automatically as part of the pre-bend. On tablature, guitar pre-bends are notated using a solid vertical line with an arrowhead at the top, a bend interval above the arrowhead, and a small fret number below the line to indicate the start pitch.

Guitar pre-bend on notation staff
Guitar pre-bend on tablature
Guitar pre-dives

Guitar pre-dives indicate that the performer should use the vibrato bar to lower the pitch before playing the note. The pitch can then be raised after starting to sound.

On notation staves, guitar pre-dives appear the same as guitar pre-bends. On tablature, guitar pre-dives are notated using a dashed vertical line with an arrowhead at the top, a bend interval above the arrowhead, and a small fret number below the line to indicate the start pitch.

Guitar pre-dive on notation staff
Guitar pre-dive on tablature
Note
  • You can change the appearance of multiple consecutive guitar pre-bends/pre-dives on the Guitar Bends page in Engraving Options. Subsequent notes with guitar pre-bends/pre-dives are known as “re-strikes”.

  • By default, stems, stem flags, and beaming appear stem-up on tablature in single-voice contexts, which means they can collide with guitar bends, pre-bends/pre-dives, and dives and returns. Therefore, in projects where you want to show both these notations and rhythms on tablature, we recommend that you change the Default stem direction to Down on the Tablature page in Engraving Options.