You can change the thickness of continuation lines individually, independently of your project-wide settings. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Prerequisite
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
-
Graphic Editing is selected in the Engrave toolbox.
-
You have chosen the appropriate property scope for local properties.
Procedure
Result
Increasing Line width makes pedal continuation lines thicker, decreasing the value makes pedal continuation lines thinner. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
You can change the default thickness for all pedal continuation lines project-wide in the Design section of the Pedal Lines page in Engraving Options.