You can change the size of the gaps in dashed/dotted ties individually, independently of your project-wide settings. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Prerequisite
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
-
Graphic Editing is selected in the Engrave toolbox.
-
You have chosen the appropriate property scope for local properties.
Procedure
- In Engrave mode, select the individual dashed/dotted ties whose gap size you want to change.
- In the Properties panel, activate Gap in the Ties group.
- Change the value in the value field.
Result
Increasing the value makes the gaps between dashes/dots larger. Decreasing the value makes the gaps between dashes/dots smaller. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
You can change the default size of the gaps between dashes/dots in all dashed/dotted ties project-wide
.