You can listen to the music you have written from the beginning of your project or from a specific point. You can use playback key commands in any mode.
Prerequisite
-
You have applied a playback template to the project that includes sounds for the instruments in your project.
-
If you want to use different sounds for different voices, you have enabled independent voice playback for those instruments.
Procedure
-
Start playback in one of the following ways:
-
To play back from the earliest selected item, make a selection, then either press P,
click Play From Selection
in the Transport window, or choose .
Tip
-
To play back all instruments, select a single note.
-
To play back only a single staff, select multiple items on the staff.
-
To play back multiple staves, select items on multiple staves.
This does not affect which channels are soloed or muted in the Mixer.
-
To continue playback from the playhead position, either press Space or Enter, click Play
in the mini transport, click Play From Playhead Position
in the Transport window, or choose .
-
To play back from the last playback start position, press Shift-Space or choose . This works even if you have since deselected the item at that position.
-
To play back from the start of the flow, press Shift-Alt/Opt-Space or choose .
-
To play back from the start of the project, choose .
-
Optional: Move the playhead during playback to later/earlier positions.
-
Optional: To enable/disable the metronome click, click Click
in the Transport window or mini transport.
Tip
You can assign a key command for Enable Click on the Key Commands page in Preferences.
-
Stop playback in any of the following ways:
-
Press Space or Enter or P.
-
Press Num 0 (0 on a numeric keypad).
-
In the mini transport, click Stop
.
-
In the Transport window, click Stop
.
Tip
If you notice a change in sound when stopping playback, you can deactivate Reset controllers and send ‘all notes off’ when stopping playback on the Play page in Preferences.