You can input specific regions in which you want to show chord symbols; for example, if an instrument that does not need chord symbols for most of the project has an improvisation section that requires chord symbols to be shown.
Procedure
-
In Write mode, do one of the following:
-
Start note input.
-
Select the region on the staff where you want to show chord symbols.
-
-
Open the chord symbols popover in any of the following ways:
-
Press Shift-Q.
-
In the Notations toolbox, click Popovers , then Chord Symbols .
-
- Enter reg into the popover.
- Press Return to close the popover.
Result
During note input, chord symbol regions are input spanning the duration of the selected note or item, which is usually the last input note. When adding chord symbol regions to existing music, they span the selected duration.
The player holding the corresponding instrument is automatically set to show chord symbols in chord symbol regions and slash regions, even if it was set to hide all chord symbols before.
You can also input chord symbol regions by choosing You can assign a key command for this option on the Key Commands page in Preferences.
.