You can input repeat markers using the Repeat Structures panel, both during note input and by adding them to existing music.
Procedure
-
In Write mode, do one of the following:
-
Start note input.
TipDuring note input, you can select additional notes before/after the last input note without deactivating the caret by pressing Shift-Right Arrow/Shift-Left Arrow.
-
Select an item at the rhythmic position where you want to input a repeat marker.
For repeat jumps, we recommend that you select the barline with which you want the end of the jump instruction to align. For repeat sections, we recommend that you select the barline with which you want the start of the section marker to align.
-
- In the Notations toolbox, click Panels , then Repeat Structures to show the Repeat Structures panel.
-
Click the repeat marker you want to input in any of the following sections:
-
Repeat Jumps
-
Repeat Sections
-
Result
During note input, repeat markers are input at the caret position. Coda sections are automatically formatted so that there is a gap between the coda and the preceding material.
When adding repeat markers to existing music, they are input at the rhythmic position of the earliest selected item.
Repeat markers that indicate the end of a section, such as Fine and D.C. al Coda, are right-aligned with the selected rhythmic position.