You can make individual dynamic points input in the Dynamics editor constant or linear; for example, if you want some points in a region to be constant.
These steps do not apply to the points of dynamics input in Write mode.
Prerequisite
-
The lower zone is shown.
-
Key Editor
is selected in the lower zone toolbar. -
Select
is selected in the Key Editor panel toolbar. -
You have selected the instruments that you want to show in the Key Editor.
-
You have added the Dynamics editor to the Key Editor.
Procedure
- In the Dynamics editor, select the dynamic points you want to make constant/linear.
-
Do one of the following:
-
To make the selected points constant, click Convert to Constant Point
in the editor header. -
To make the selected points linear, click Convert to Linear Point
in the editor header.
-
Result
The selected dynamic points become constant or linear.
Value lines always appear horizontal after constant points. Value lines appear angled after linear points if the next point has a different value, indicating a smooth transition between the points.
Example
|
|