You can change how often counts are shown on individual one-bar repeat regions, independently of your project-wide setting; for example, if you want to show the count after eight bars on a single bar repeat region.
Note
Bar repeat counts are only shown on one-bar repeat regions.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the one-bar repeats whose count frequency you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Count frequency in the Bar Repeat Regions group.
- Change the value in the value field.
Result
The count frequency is changed for the selected bar repeat regions.
Tip
You can also change the default count frequency for all bar repeat regions project-wide in .