You can delete custom changes to bracket/brace grouping and barline joins; for example, if you change your mind about where you want to reset the bracket/brace grouping.
Prerequisite
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the bracket and barline change signposts that you want to delete. You can do this in Write mode and Engrave mode.
- Press Backspace or Delete.
Result
The selected bracket and barline changes are deleted. Staff grouping on any corresponding systems follows either the previous bracket and barline change or the project-wide staff grouping settings if there is no previous bracket and barline change.
Tip
-
In Engrave mode, you can also select the brackets/braces you want to delete.
-
You can also delete individual barline joins independently of other barline joins and bracket/brace grouping changes at the same rhythmic position.