Changing the size of chord diagrams

You can change the size of all chord diagrams project-wide, expressed as a scale size relative to chord symbols. Chord diagrams are automatically scaled proportionally when you change the size of individual chord symbols.

Note

These steps only apply to chord diagrams shown alongside chord symbols. You can change the size of chord diagrams in used chord diagrams grids in Layout Options > Chord Symbols and Diagrams > Chord Diagrams.

Procedure

1. Press Ctrl/Cmd-Shift-E to open Engraving Options.
2. In the category list, click Chord Diagrams.
3. In the Design section, change the value for Scale factor relative to chord symbol.
4. Click Apply, then Close.

Result

The scale size of all chord diagrams project-wide relative to chord symbols is changed.