You can show individual chord symbols either above or below the staff, independently of your project-wide setting. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox. -
You have chosen the appropriate property scope for local properties.
Procedure
- Select the chord symbols whose staff-relative placement you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Placement in the Chord Symbols group.
-
Choose one of the following options:
-
Above
-
Below
-
Result
The staff-relative placement of the selected chord symbols is changed. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
-
You can choose to show chord symbols between the staves of grand staff instruments in each layout independently in .
-
You can change the default placement of all chord symbols project-wide in .