Flared ends are usually shown at the end of crescendo hairpins and indicate a sudden burst in volume at the end of the crescendo. You can hide/show flared ends on any hairpin.
Note
You can only show flared ends on hairpins with solid lines.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the hairpins on which you want to hide/show flared ends. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate/deactivate Flared end in the Dynamics group.
Result
A flared end is shown on the selected dynamics when Flared end is activated, and hidden when it is deactivated.
Example
|
|