You can show only a single left or right bracket on individual bracketed figured bass figures. For example, if you want to indicate that all figures between two bracketed figures are optional. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Prerequisite
-
You have input figured bass figures with brackets.
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox. -
You have chosen the appropriate property scope for local properties.
Procedure
- Select the bracketed figures on which you want to show a single bracket. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Hide single bracket in the Figured Bass group.
-
Choose one of the following options:
-
Start
-
End
-
Result
Brackets are hidden on the corresponding side of the selected figures, leaving a single bracket on the other side. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Example
|
|