You can hide/show individual figured bass figures in layouts in which figured bass is shown. You can do this for the current layout and frame chain only, or for all layouts and frame chains. However, you cannot show individual figures in layouts where figured bass is hidden.
Prerequisite
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
-
If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.
-
You have chosen the appropriate property scope for local properties.
Procedure
- Select the figured bass figures you want to hide, or the signposts of figures you want to show. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate/deactivate Hidden in the Figured Bass group.
Result
The selected figured bass figures are hidden when Hidden is activated, and shown when it is deactivated. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Signposts are shown at the position of each hidden figure. However, signposts are not printed by default.
-
You can hide/show figured bass signposts by choosing
. -
You can assign a key command for Hide/Show Item on the Key Commands page in Preferences.