You can change fingerings after you have input them; for example, if you decide a different fingering would be better.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the fingerings you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, enter the new fingering you want into the Finger or position value field in the Fingering and Positions group.
- Press Return.
Result
The selected fingerings are changed.
Tip
You can also change existing fingerings in Write mode by opening the fingerings popover. Any existing fingerings on the selected note are shown in the popover.