You can change the maximum number of fermatas that appear on each staff at individual positions when there are multiple voices on a staff.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the fermatas whose maximum number per staff you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Max. fermatas per staff in the Holds and Pauses group.
-
Select one of the following options from the menu:
-
One per voice
-
One per each side of staff
-
One per staff
-
Result
The number of fermatas shown at the selected positions is changed.
Tip
You can change the maximum number of fermatas that can appear on a single staff project-wide on the Holds and Pauses page in Engraving Options.