You can change the staff position of horizontal lines shown inside the staff, including changing the staff position of the start/end of lines independently of each other; for example, if you want lines to appear angled.
Prerequisite
-
The horizontal lines whose staff position you want to change are placed inside the staff and have at least one barline-/rhythmic position-attached end.
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
-
If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.
Procedure
- Select the horizontal lines placed inside the staff whose staff position you want to change. You can do this in Write mode and Engrave mode.
-
In the Properties panel, activate the following properties, individually or together, in the Horizontal Lines group:
-
Start position
-
End position
-
- Change the values in the value fields.
Result
The staff positions of the corresponding ends of the selected lines are changed according to the new values. For example, 0 is the middle line of the staff, 4 is the top line of the staff, and -4 is the bottom line of the staff.