You can change the continuation type used for individual pedal lines, independently of your project-wide settings. For example, if you want some pedal lines to show a dashed line and a sign at the end, but others to show a line and end hook.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the pedal lines whose continuation type you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Continuation type in the Pedal Lines group.
-
Select one of the following continuation types from the menu:
-
Line
-
Sign at End
-
Sign at End and Dashed Line
-
None
-
Result
The continuation type of the selected pedal lines is changed.
Tip
You can change the continuation type for all pedal lines project-wide on the Pedal Lines page in Engraving Options. You can choose different continuation types for each pedal type; for example, you can have a line for sustain pedal lines and just a sign at the end for una corda pedal lines.
Example
|
|
|
|