You can hide/show repeat markers individually; for example, if you want a separated coda section without showing the coda symbol and text.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the repeat markers you want to hide, or the signposts of repeat markers you want to show. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate/deactivate Hide in the Repeat Markers group.
Result
The selected repeat markers are hidden when Hide is activated, and shown when it is deactivated.
Signposts are shown at the position of each hidden repeat marker. However, signposts are not printed by default.
Tip
You can hide/show repeat marker signposts by choosing .