You can change the index of individual repeat markers; for example, if a flow requires two different codas with different symbols so players can tell them apart.
By default, all repeat markers of the same type have the same appearance, even when there are multiple repeat markers in the flow.
You cannot change the index of Fine or D.C. repeat markers.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
Result
Marker index changes the order of the selected repeat marker relative to other repeat markers of the same type.
‘Jump to’ index changes the destination of the selected repeat marker.
You can change the default appearance of all multiple repeat markers project-wide in .
Example
If you have two codas in a flow with two different D.S. al Coda markers, you might set Marker index to 1 for the first coda and 2 for the second, then set ‘Jump to’ index to 1 for the first D.S. al Coda marker and 2 for the second.
|
|