You can change how frequently counts are shown on individual slash regions, independently of your project-wide setting; for example, if you want to show the count after eight bars on a single slash region. By default, slash region counts are shown every four bars.
Prerequisite
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
-
If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.
Procedure
- Select any part of each slash region whose count frequency you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Count frequency in the Slash Regions group.
- Change the value in the value field.
Result
The count frequency is changed for the selected slash regions.
Tip
You can also change the default count frequency for all slash regions project-wide in
.