You can show the counts in individual slash regions either above or below the staff, independently of your project-wide setting. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Note
Changing the staff-relative placement of counts affects all counts in the region. You cannot change the placement of a single count independently of other counts in the region.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox. -
You have chosen the appropriate property scope for local properties.
Procedure
- Select any part of each slash region whose count staff-relative placement you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Count position in the Slash Regions group.
-
Choose one of the following options:
-
Above
-
Below
-
Result
The staff-relative placement of all counts in the selected slash regions is changed. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
You can change the default placement of all slash region counts project-wide in .