You can hide/show stems and beams, where applicable, on slashes in individual slash regions. By default, slashes in slash regions are shown without stems.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select any part of each slash region in which you want to hide/show stems. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Slash type in the Slash Regions group.
-
Choose one of the following options:
-
With stems
-
Without stems
-
Result
Stems are hidden in the selected slash regions when you choose Without stems, and shown when you choose With stems.
If appropriate for the prevailing meter, such as 3/8, beams are shown in addition to stems.