You can change the thickness of dashed and solid lines in individual gradual tempo changes, independently of your project-wide settings. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Note
These steps only apply to gradual tempo changes with dashed and solid lines.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
Graphic Editing
is selected in the Engrave toolbox. -
You have chosen the appropriate property scope for local properties.
Procedure
- In Engrave mode, select the gradual tempo changes whose thickness you want to change.
- In the Properties panel, activate Line thickness in the Tempo group.
- Change the value in the value field.
Result
Increasing the value makes dashed and solid lines thicker, decreasing the value makes dashed and solid lines thinner. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
Tip
You can change the thickness of all dashed and solid gradual tempo change lines project-wide on the Tempo page in Engraving Options.