You can show individual metronome marks as approximate, and change the appearance of the approximate indication.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the metronome marks that you want to show as approximate. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Is approximate in the Tempo group.
-
Optional: Change the appearance of the approximate indication in any of the following ways:
-
Activate Approximate appearance, then select the approximate appearance you want from the menu.
-
Activate Show equals sign, then activate/deactivate the corresponding checkbox.
-
Result
The selected metronome marks are shown as approximate.
Tip
You can change the default appearance of all approximate metronome marks project-wide on the Tempo page in Engraving Options.