Showing the metronome mark value as a range

Dorico Pro Help

Product
Dorico Pro
Version
5.1
Language
English
Document type
Webhelp
ft:openMode
fluidtopics

You can show the metronome mark value of individual absolute tempo marks as a range. For example, you can use this to indicate that any speed within the given range is musically appropriate for the piece.

Note

These steps do not apply to gradual tempo changes or reset/relative tempo marks.

Prerequisite

  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

  • If you are in Engrave mode, Graphic Editing Graphic Editing button is selected in the Engrave toolbox.

Procedure

  1. Select the absolute tempo marks whose metronome mark values you want to show as a range. You can do this in Write mode and Engrave mode.
  2. In the Properties panel, activate Tempo range (bpm) in the Tempo group.
  3. Change the value in the value field.

Result

The tempo range, expressed as beats per minute, is changed for the selected tempo marks. By default, metronome mark ranges use a dash separator.

Note
  • Depending on the values set for each property, both Tempo (bpm) and Tempo range (bpm) can be the minimum/maximum tempo in the range, as Dorico Pro automatically arranges metronome mark ranges with the lower value first. However, the metronome mark used for playback is always Tempo (bpm), regardless of whether that is the higher/lower value in the range.

  • You can change the default separator used for metronome mark ranges in Engraving Options > Tempo > Absolute Changes.