Changing the shape/angle of ties

Dorico Pro Help

Product

Dorico Pro

Version

5.1

Language

English

Document type

Webhelp

ft:openMode

fluidtopics

You can change move ties and tie handles graphically, allowing you to change the shape and/or angle of individual ties; for example, to adjust an endpoint relative to an individual notehead. You can do this for the current layout and frame chain only, or for all layouts and frame chains.

Prerequisite

Graphic Editing is selected in the Engrave toolbox.
You have chosen the appropriate property scope for local properties.

Procedure

In Engrave mode, select the whole ties or individual tie handles you want to move in any of the following ways:
- Ctrl/Cmd-click multiple ties.
- Ctrl/Cmd-click individual handles on multiple ties.
- Select a whole tie and press Tab to cycle through its handles until the one you want to move is selected.
- Click the handle you want to move.
Note
- To change the angle of ties, select tie endpoints only.
- You can show handles on all items, not just selected items, by choosing Engrave > Show Handles > Always. This can make it easier to select individual handles on multiple items.
- You cannot move whole ties to the right/left, you can only move them upwards/downwards.
Move the ties or handles in any of the following ways:
- To move them a standard amount to the right, left, up, or down, press Alt/Opt plus the corresponding arrow key. For example, press Alt/Opt-Left Arrow to move handles to the left. This moves ties/handles by 1/8 space per press.
- To move them a large amount, press Ctrl/Cmd plus the standard key command; for example, Ctrl/Cmd-Alt/Opt-Left Arrow. This moves handles by 1 space per press.
- To move them a moderate amount, press Shift plus the standard key command; for example, Shift-Alt/Opt-Left Arrow. This moves handles by 1/2 space per press.
- To move them a small amount, press Ctrl/Cmd-Shift plus the standard key command; for example, Ctrl/Cmd-Shift-Alt/Opt-Left Arrow. This moves handles by 1/32 space per press.
- Click and drag whole ties upwards/downwards.
- Click and drag them in any direction.
  
  Tip
  To constrain movement either horizontally or vertically, start dragging, then press and hold Shift.

Result

The selected ties or tie handles are moved. Depending on the handles you selected and the directions in which you moved them, this can change the shape, angle, and/or proportional size of the corresponding ties. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.

Tip

The following properties in the Ties group of the Properties panel are activated automatically when you move the corresponding tie handles:

Start offset moves the left endpoints of ties. X moves them horizontally, Y moves them vertically.
End offset moves the right endpoints of ties. X moves them horizontally, Y moves them vertically.
Start handle offset moves the left control points of ties. X moves them horizontally, Y moves them vertically.
End handle offset moves the right control points of ties. X moves them horizontally, Y moves them vertically.

You can also use these properties to change the shape of individual ties by changing the values in the value fields.

Deactivating the properties resets the corresponding handles on the selected ties to their default positions.

Example

Moving the left endpoint moves both the start of a tie and the other handles apart from the right endpoint. This allows you to change the angle and/or width of the tie without changing its overall shape.

Moving the left control point causes the tie height handle to move but does not affect the position of the left and right endpoints or right control point. This gives you fine control over the shape of ties while ensuring that the end result remains curved and smooth.