You can change the angle of individual tuplet brackets so that they appear horizontal, independently of your project-wide setting. You can do this for the current layout and frame chain only, or for all layouts and frame chains.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox. -
You have chosen the appropriate property scope for local properties.
Procedure
- Select the tuplet brackets whose angle you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Force horizontal in the Tuplets group.
Result
The selected tuplet brackets appear horizontal when the property is activated. If the property scope was set to Locally, this change only takes effect in the current layout and frame chain.
When the property is deactivated, the selected tuplet brackets follow your project-wide setting for angled tuplet brackets.
Tip
You can change whether all tuplet brackets can appear angled or always appear horizontal project-wide in .