You can input guitar post-bends on any existing notes belonging to fretted instruments. You can also specify that post-bends are microtonal.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar. -
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the notes after which you want to input guitar post-bends. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Post-bend interval in the Guitar Post-bends group.
-
Do one of the following:
-
Change the interval as required.
-
To turn the guitar post-bends into microtonal post-bends, activate Microtone bend in the Guitar Post-bends group.
-
Result
Guitar post-bends of the specified interval are input after the selected notes. They are shown as microtonal when Microtone bend is activated.