You can hide/show wings on individual repeat barlines, independently of your project-wide setting.
Prerequisite
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar.
-
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
Procedure
- Select the repeat barlines on which you want to hide/show wings. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Show wings in the Time Signatures group.
- Activate/Deactivate the corresponding checkbox.
Result
Wings are shown on the selected repeat barlines when the checkbox is activated, and hidden when it is deactivated.
When the property is deactivated, repeat barlines follow your project-wide setting.
Tip
You can hide/show wings on all repeat barlines project-wide in .
Example
|
|
|