You can change the direction of coordination lines; for example, to make a line with an arrow cap appear upside-down with the arrow at the opposite end.
-
The lower zone is shown.
-
Properties
is selected in the lower zone toolbar.
-
If you are in Engrave mode, Graphic Editing
is selected in the Engrave toolbox.
- Select the coordination lines whose direction you want to change. You can do this in Write mode and Engrave mode.
- In the Properties panel, activate Reverse in the Coordination Lines group.
- Activate/Deactivate the corresponding checkbox.
The selected coordination lines appear reversed when the checkbox is activated, and following the default direction for the line style when the checkbox is deactivated.
When the property is deactivated, coordination lines follow your project-wide setting for coordination line direction.
You can change the default direction of all coordination lines project-wide on the Coordination Lines page in Engraving Options.
|
|
|