The results of the global analysis are marked with hot points. You can navigate to these points to see the results of the analysis and to check whether there are any issues in your audio.
Prerequisite
In the Audio Editor, you have selected the Analyze tab, clicked Global Analysis, and performed the analysis.
Procedure
-
In the Global Analysis dialog, click the tab that represents the values that you want to check.
-
Check the display for maximum/minimum values in the entire analyzed section.
-
Decide which of these values you want to check.
-
Click the values.
-
Check the Number of Points value at the bottom of the dialog.
The value shows the number of positions that were detected in the analysis.
-
Use the scrollbar below the Number of Points value to navigate to the detected positions.
The edit cursor shows the position in the Waveform display.
-
To check another property, click the corresponding tab, then the value button.
Note
The result of the analysis is saved until you close the dialog or click Analyze again.