Compressor

The Compressor module allows a signal to be split into two frequency bands. You can specify the level, bandwidth, and compressor characteristics for each band.

Band Settings

On/Off: Activates/Deactivates the corresponding section.
Solo Band: Solos the corresponding frequency band.
Add/Remove Band: Allow you to add and remove bands.

Standard

Allows you to create smooth compression effects.

THRESH (-60 to 0 dB): Signal levels above the set threshold trigger the compressor.
ATT (0.1 to 100 ms): Determines how fast the compressor responds. If the attack time is long, more of the initial part of the signal passes through unprocessed.
REL (10 to 1000 ms): Sets the time after which the gain returns to its original level. If Auto Release is activated, the plug-in automatically finds a suitable release setting for the audio.
Ratio: Sets the amount of gain reduction applied to signal above the set threshold.
Mix: Sets the level balance between the dry and the wet signal.
Compressor curve display: Graphically illustrates the compressor curve that is shaped according to the Threshold and Ratio parameter settings.
Output: Sets the output gain.

Tube

This versatile compressor with integrated tube simulation allows you to produce smooth and warm compression effects.

Input: In combination with the Output setting, this parameter determines the compression amount. The higher the input gain setting and the lower the output gain setting, the more compression is applied.
ATT (0.1 to 100 ms): Determines how fast the compressor responds. If the attack time is long, more of the initial part of the signal passes through unprocessed.
REL (10 to 1000 ms): Sets the time after which the gain returns to its original level. If Auto Release is activated, the plug-in automatically finds the best release setting for the audio.
Drive: Controls the amount of tube saturation.
Mix: Sets the level balance between the dry and the wet signal.
Output: Sets the output gain.