Reverb - X-Stream - 1.0

Determines the amount of time between the dry signal and the onset of the reverb. With higher Predelay values, you can simulate larger rooms.

Controls the dimensions of the simulated room. With a setting of 100%, the dimensions correspond to a cathedral or a large concert hall. With a setting of 50%, the dimensions correspond to a medium-sized room or studio. Settings below 50% simulate the dimensions of a small room or a booth.

Adjusts the echo density of the reverb tail. With a setting of 100%, single reflections from walls cannot be heard. The lower this value, the more audible the single reflections.

Controls the attack of the reverb tail. With a setting of 0%, the attack is more immediate, which is a suitable setting for drums. The higher this value, the less immediate the attack.

Adjusts the output of the reverb signal between mono and stereo. With a setting of 0%, the output of the reverb is mono. At 100%, it is stereo.

Activates/Deactivates the chorusing effect.

Specifies the frequency of the pitch modulation.

Sets the intensity of the pitch modulation.

Controls the overall reverb time of the tail. The higher this value, the longer the reverb tail will decay. With a setting of 100%, the reverb time is infinitely long. The Main Time parameter also represents the mid band of the reverb tail.

Controls the reverb time for the high frequencies of the reverb tail. With positive values, the decay time of the high frequencies is longer. With negative values, it is shorter. Frequencies are affected depending on the High Freq parameter.

Controls the reverb time for the low frequencies of the reverb tail. Positive values result in a longer decay for the low frequencies. Negative values result in a shorter decay.

Frequencies are affected depending on the Low Freq parameter.

Attenuates the high frequencies of the early reflections. The lower this value, the fewer high frequencies are present in the early reflections.

Sets the ratio between the dry and the wet signal.