The X-LFO page provides two LFOs combined into a single unit. It can be used to modulate two-dimensional XY parameters, with one LFO modulating the X-value and the other LFO the Y-value, for example.
Both LFOs can be configured individually and provide a Rate parameter that can be modulated.
- Select LFO X/Select LFO Y
-
Allows you to select the LFO for which the modulation rows are to be shown on the right.
- Phase display
-
Visualizes the current phase.
- Rate X/Rate Y
-
Sets the rate for the X-LFO.
- Waveform
-
The buttons above the 13 Rate steps allow you to select their waveforms. You can assign 13 different waveforms, which means that changing the speed of the LFO can also change the waveform.
Const values send a constant output value.
Hold maintains the last value until the LFO switches to the next waveform.
-
To select a waveform, click the Waveform button for the corresponding Rate step, and select the waveform from the menu.
-
To set a waveform for all Rate steps at the same time, click on the Set All Waveforms
button to the left of the waveform buttons, and select it from the pop-up menu.
-
- Sync to Host Tempo
-
Activate Sync to synchronize the LFO to the host tempo.
- Tempo
-
If Sync is deactivated, you can enter the reference tempo in the Tempo field.
Modulation Rows
To the right of the LFO settings, the modulation rows are shown.
Before you set up the parameters, make sure that the LFO that you want to use for modulation is active.